Comments

• Sounds like a great job! At the moment, in my little Mecway experience, 50% of the problems are related to meshing when importing STP files from a CAD software, even when the Step file is well done with all the faces perfectly coinciding!

  in Conformal meshes with Gmsh Comment by Rino_aic January 2022
• Thank you

  in Safety Factor Von Mises Diagram Comment by Rino_aic January 2022
• Thank you

  in Search and display of specific nodes on the mesh Comment by Rino_aic January 2022
• Thank you again disla

  in Meshing error depending from orientation of the same model Comment by Rino_aic January 2022
• Hi disla, Could you attach your liml file?. Thanks

  in Meshing error depending from orientation of the same model Comment by Rino_aic January 2022
• Thank you disla Absolutely yes, I need for an initial linear solution to then transfer the macro-results to the single details to deepen with the non-linear checks. The tank is not the subject of the analysis, and an LGP tank is subject to a maxim…

  in Meshing error depending from orientation of the same model Comment by Rino_aic January 2022
• Thank you Guys... The problems I'm encountering with MECWAY are not only related to meshing, but in very long attempts to analyze FEA that return errors or with solutions that do not converge. In the attached example I'm trying to find a configura…

  in Meshing error depending from orientation of the same model Comment by Rino_aic January 2022
• Sorry... wrong file

  in Meshing error depending from orientation of the same model Comment by Rino_aic January 2022
• Thank you JohnM, I will deepen your valuable suggestions

  in Bolted connections approach Comment by Rino_aic January 2022
• Thank you Victor and Mike.

  in Bolted connections approach Comment by Rino_aic January 2022
• Although I am a perfect beginner in using Macway FEA, I can only confirm that the part relating to connections with moving elements (bolts, screws, etc. etc.) is normally neglected in most FEA / FEM softwares. However, I wouldn't agree that it could…

  in Bolted connections approach Comment by Rino_aic January 2022
• Thank you Victor

  in Bonded Contact parametres Comment by Rino_aic December 2021
• Thanks, but with 1 mm maximum element size and 0.001 (M.N. o E.) I have the error. . With 10 mm and 0.001 in MIN. number of elements per curve I have loss of details in the mesh!

  in Meshing issue Comment by Rino_aic December 2021
• Yes, in my second version I modified the model to have a tubular section and to better verify the behavior of the intersections of the parts of the solid generated in Rhinoceros. So I left all solid hollow elements. Unfortunately, even in this secon…

  in Meshing issue Comment by Rino_aic December 2021
• Thanks Victor, but now a question is needed. That parameter that I had intended as the maximum value of the size of the single mesh element, based on what considerations should it be attributed? If in my model there are elements with a thickness of …

  in Meshing issue Comment by Rino_aic December 2021