I recall importing it in and leaving it with linear elements while I mirrored and stitched the sections together. Then, I would use custom refinement to bump up the refinement in areas of concern. Also, since I'm using composite properties I had t…
It the nature of the beast (FEA using laminates with shells). I doubt any product out there has a better solution. It would go a long way to help if the tree view didn't re-initialize when changes were made and there was some way of ordering the c…
I can confirm that... Back during the Lisa version, I had a utility program that would read the output file and change the input file and do a real basic version of a compression only support. It would only work on a plane. I never added the requi…
The frustration isn't too bad. :-) I'm getting spoiled with Mecway. I would not have even attempted a model of this size to run at all on either the IBM-3090 or Cyber super computers I had access to back in the 80's and 90's.
I would like to suggest that there be some way to pause and evaluate an on-going analysis that uses compression-only-support. That after I look at the intermediate results, I could choose to stop the analysis (keeping the current step’s results) or…
Welcome Ormond,
As a temporary work-around...
I don't know your specific tools or situation; however, I know this works for the stl format and I'm thinking it would work for dxf.
1) Export from your CAD program individual layers into separate dxf…
Hi Victor,
Just for grins and see if it starts converging, I ran a series of tests just changing the Convergence tolerance. As you mention, it did finally and suddenly drop. Here are some stats...
Tolerance Iterations Time Converge
0.1 …
Hi Victor,
Thank you for your quick reply. In the old days, we never went non-linear. So, your explanation is definitely helping me get there. Am I correct in assuming that this summation of “all”… is all the nodes that make up the contact co…
By far and away the most highly stressed components on the Z40 are the Swing Keels. For those not familiar with sail boat jargon, this is a wing that runs vertically in the water so that the lateral loads on the sails are resisted. Instead of crab…