Comments

• Thank You

  in Calculate forces and moments from dynamic analysis Comment by PaulFlynn February 2022
• Ok,  I guess I'll answer my own question.  Set up the model with the redundant BC's on the symmetry plane and the bonded contact.  Run CCX.  It will fail, but it will write out the input file.   Open the input file and copy the *BOUNDARY lines.  P…

  in Displacement constraints on slave nodes in bonded contact Comment by PaulFlynn April 2017
• Thank You.

  in Why can't MECWAY write *FILM lines in a CCX input file? Comment by PaulFlynn April 2017
• Victor Thanks for including *Film in the new version.  Also, is there a limit to the number of lines you can write on the CCX step window?  For big models it truncates the copy. Paul

  in Why can't MECWAY write *FILM lines in a CCX input file? Comment by PaulFlynn April 2017
• Victor This works: *Equation 2 3,2,1,4,2,-1 *Equation 2 4,2,1,5,2,-1 *MPC Plane Top_Nodes Nodes 3,4,5 are in the node set Top_Nodes Thanks, Paul

  in Constraint Equations with named surfaces Comment by PaulFlynn March 2017
• Sergio and Andrea Thanks for your help.  I got everything working.  One question. Is there a full list of CCX commands that I can refer to in the future? What is the source of the clip you posted? Paul

  in Extract forces on contact surfaces Comment by PaulFlynn February 2017
• OK.  I took out the * and it works.  Does the * make it a comment?

  in Extract forces on contact surfaces Comment by PaulFlynn February 2017
• No. My screen stops at FORC_F3.  See attachment.  It shows the input file and the results screen Paul

  in Extract forces on contact surfaces Comment by PaulFlynn February 2017
• OK, I put the CONTACT FILE CDIS, CSTR command in the CCX custom step contents and the model runs, but where do the contact disp and pressures come out?  I don't see anything different in MECWAY.  Do I need a CalculiX reader? Paul

  in Extract forces on contact surfaces Comment by PaulFlynn February 2017