Comments

• Hello Sergio, Thanks a lot. The simulation is running under your recommended cards. Thanks. Best regards,

  in Stress-strain curve. Material card. Comment by FOL April 2019
• Thanks.

  in Joule heating Comment by FOL November 2018
•   Thanks Victor. Yes, the idea was to split the simulations in two steps and modify the friction and outputs from one step to the other. By doing the gradual transition that you recommended, the simulation is has converged. I’m currently analyzing …

  in Propagating displacements Comment by FOL October 2016
• Thanks.

  in Stress level too high Comment by FOL November 2015
• Thanks Victor. I use CCX for the non-linear analysis and, as you said, the stresses decreased significantly. Sorry for the following basic question, but I am not familiar with the "boundary" command. What is exactly constrained with 1,1,1 or 2,2,1?.…

  in Stress level too high Comment by FOL November 2015
• Thanks Victor. Please find enclosed the original document (*.liml). I will try with non linear analysis.

  in Stress level too high Comment by FOL November 2015
• Yes, you are right. It's a typographic error. Density considered= 7.85 g/cm3

  in Stress level too high Comment by FOL November 2015