Stuck? 
support@mecway.com
support@mecway.com
Mecway
FEA
KundertdeWit
About
- Username
- KundertdeWit
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
@Sergio, @Mishal, Many thanks for your valuable input. It has been added to version 2026.4, which is available now @Mishal: the functionality has been added, but a bit differently than you did it. Please check if this indeed does what it should do.
-
@Mishal, I have merged your work into my main branch. The new release 2026.3 is available now. Could you please check and test if it indeed covers your work? Could you also check the frequency analysis again (in another forum thread), regarding the…
-
@Sergio: in /TestFiles you can find an example with Tiecontact for plates
-
@ Mishal, I did the same :-), I was reading your post just now. I checked if my changes cover yours, which is not the case. I will add this to the next release, which will be available tonight I think Release 2026.2 is available just now, with some …
-
@Sergio, regarding 'can you share some example using TIE on two shells (surface to suface)? I have make it work TIE with solid, but not with shells' I am not sure about TIE with shells. I will look it up for you, but give me some time. In the meanw…
-
Hi all, I have been long time looking for a nice GUI for Code-Aster. I have been using Salome-Meca, but always find it too tedious to use. In the first half of this year I established the working principle of a bridge between Mecway as pre-/post pr…
-
Hi all, I have been long time looking for a nice GUI for Code-Aster. I have been using Salome-Meca, but always find it too tedious to use. In the first half of this year I established the working principle of a bridge between Mecway as pre-/post pr…
